Li-Nicomn Battery 3s 12V 10A to 200A Electric Bicycles Battery Monitoring System

Product Description

Li-NiCoMn Battery 3S 12V 10A To 200A Electric Bicycles Battery Monitoring System


1. We can design it for various lithium batteries like LiFepo4, LiMn2O4, and Li-polymer etc.

2. The main functions are: over charge protection, over discharge protection, over
current protection, short-circuit protection, temperature protection etc.
3. According to the customer request we can develop PCM in different sizes and structures.
4. BMS manufactured by high quality Mos and IC imported . Keep your battery long cycle service life time.

Product Parameters

Name	Item	Spec
Power balancing	Power balancing	2.65V
	Balance release volt	2.65V
	Balance current	40±5mA
Over discharge protection	Over discharge detect volt	2.8±0.05V
	Over discharge detect delay	0.5V
	Over discharge volt release	3.0±0.05V
Over current protection	Over current detect volt	150mV
	Over current detect delay	9MS
	Over current protection	Can be customized
	Over current protect release	Disconnect load
Short circuit protection	Short circuit protection	External load short circuit
	Short circuit detect delay	250uS
	Short circuit detect release	Disconnect load
Temperature protection		Can be customized
Resistance	Main circuit resistor	≤10mΩ
Self-consumption	Working current	≤100uA
	Sleepy current (when battery is over discharged )	≤20uA
Working temp	Temp range	-20/+80ºC

Product Details Show
  

How To Select BMS


Why Choose Us
Advantages


Various Available Battery Type

Professional Technical Support

Wide Application


Certifications
    

Our Factory



FAQ
1. Which current of the PCB should i choose?
Take 13S 48V pack as an example: Which PCB you should choose depends on the power of
your motor or the current limitation of your controller. Below 350W ,you can choose 16A.
Below 500W, you can choose 18A, Below 800W, you can choose 35A,Below 1KW, you can
choose 60A. Above 1200W, the same. If you are not sure, please contact us freely.

2. Can i use bigger size of PCB than it should?
Suppose you need 60A PCB but you chose 80A, that is OK. 
80A allows higher current.Nothing bad but a bit higher price.
But if you choose 50A, sorry it is too small. So you can choose higher spec but can't choose
lower one than it should have been.

3. What kind of charger should i choose?
Lithium battery must be charged by lithium battery charger. You can't charge it with a lead
acid battery charger. The lead acid battery charger might damage MOS pipe of the PCB.

4. if i have PCB, do i need any balancers?
Yes if you can add QNBBM balancers, that would be perfect. 
The Main function of PCB is to prevent batteries from over charged or over discharged,over heated etc.
All the PCB /BMS in the world balance performance is not satisfactory. 
With balancers added, the batteries lifespan will be longer and the capacity will be fully used.

5, How to judge if my PCB is broken or not ?
If you'd like to judge if the PCB is fine or not, please use a multi-meter and see if the voltage
of each cell is close to each other or not.when the volt difference is 1V, the battery will have
such performance:driving distance is short, cut off when started, charging time is very short.
under such situation , some battery is defective. When the PCB is broken, the battery can't be
discharged when you measured the battery volt is normal.